56 The Hardware Profiles dialog is already running.
57 Confirm Profile Delete
58 Are you sure you want to delete the hardware profile "%s"?
59 You must enter a value between 0 and 500 for the number of seconds to wait for a user selection.
60 You have specified this is not a portable computer, the docking state in all other Hardware Profiles will be changed to unknown.
100 Insufficient memory for this operation;close one or more Windows applications to increase available memory.
101 System Control Panel Applet
118 Cannot open USER Environment section in Registry.\nPossible registry corruption.
119 Cannot save new Environment variables in Registry.\nPossible registry corruption.
121 You are not logged onto the Windows NT workstation as a member of the user group that has the right to view the workstation's Virtual Memory settings.
123 Incorrect value. Enter an initial page file size between 2 and the free space available on the drive.
124 Incorrect value. Enter a maximum page file size that is greater than or equal to the initial page file size, and less than %d MB.
125 There is not enough space on this drive for the paging file size specified. Please enter a smaller number or free some disk space.
126 Drive %c: is too small for the maximum paging file size specified. Please enter a smaller number.
127 Could not read the current virtual memory settings.
128 MB
129 Cannot change Boot.ini file. Operating System and Timeout changes will not be saved.
130 Drive %c: does not have enough free space for the maximum paging file size specified. If you continue with this setting, the paging file will only grow to the size of the available free space.
131 Cannot open SYSTEM Environment section in Registry.\nPossible registry corruption.
132 You are not logged onto the Windows NT workstation as a member of the user group that has the right to view the workstation's Recovery settings.
134 An error occured while saving the changes. Some changes will not be remembered.
135 Another file exists with the filename "%s". Do you wish to overwrite the existing file with a page file?
136 There is not enough space on this drive to create the page file size specified. At least %d Megabytes of free disk space must be left after the page file is created. Specify a smaller page file size or free some disk space.
137 There is not enough free space on the boot drive to enable crash recovery. At least %d Megabytes of free space on drive %c: are needed. Please free up some disk space and try again.
138 The Recovery options you chose require that the initial pagefile size on volume %c: be at least %d megabytes. Should the initial pagefile size be changed now?
139 If the pagefile on volume %c: has an initial size of less than %d megabytes, then the system is unable to create a debugging information file if a STOP error occurs. This feature will be disabled now.
140 If you want to write debugging information to a file, you must enter a filename.
141 Debugging information can be written only to local, writable disk drives. Please specify a path on a local disk drive.
142 The debugging information file path may be invalid or is currently inaccessible. Do you wish to change it?
143 The path for the debugging information file is too long. Please specify a path that is less than %ld characters.
144 The debugging information file path must be a fully qualified path such as c:\windir\memory.log
145 To increase the registry size limit by the amount specified, a bigger paging file is needed. The paging file size will be increased.
146 There is not enough space on the drives to set the registry size limit specified. Specify a smaller registry size limit or free some disk space.
147 The registry size limit must be larger than the current size of the registry. Specify a larger registry size limit.
148 The Alerter service is not running.\n\nFor an administrative alert to be sent during a STOP error, the Alerter service must be running. Please start the Alerter service by using the Services option in the control panel.
149 The %s file can not be opened. Operating System and Timeout settings can not be changed.
